HOME

LRX TRUCKS
Mobile Lighting

LRX SINGLES
6 - 12 - 18K Par

LRX PIRANHA
Mobile Lighting

LRX SCORPION
23.4K Fay Light”  thirty-six DWE bulbs

LRX RAPTOR
18K Maxi” using eighteen Par 64 bulbs

LRX TROLLEY
Powered Beam Trolley

LRX 144K LIGHTING
144K Par 64 bulbs

LRX CLAM LIGHT
16' X 36' Soft Box

LRX MOON CUBE
10' x 10' x 10'

CORRECTION FILTERS
CTO Hard Filters

NEW STUFF

FILMING PLATFORMS

AERIAL LIFT EQUIPMENT

FABRICATION SHOP

MOBILE CRANES

CRANE ACCESSORIES

PHOTO GALLERY

TRAINING

PDF DOWNLOADS

CONTACT US

RATES

**********************

LOCAL
1-416-287-3107

DURHAM
905-686-3333

TOLL FREE
1-877-688-2110

FAX
905-686-8546

KEEPING YOUR CREW SAFE & THE LIGHTS WHERE YOU WANT THEM

LRX RAPTOR
Shown With Optional LRX Trolley
LRX Raptor flyer

The design concept of using par 64 bulbs in this type of arrangement has proven its self time and time again. The Raptor head is an advance forward in safety and remote position- ability where sets are built after the lighting is installed and focusing could be a difficult or time consuming task. Tilt, pan, beam spread and the optional trolley are operated from our hand controller or any DMX type lighting console.

Fixture Features:
-Eighteen - par 64 bulbs arranged on five panels.
-Eighteen kilowatt total per fixture.
-Change density without dimming; for flexibility the fixture has been wired to accept three nineteen pin Soca-pex cables, one bulb (8.3 amps) per circuit.
-Robotics built in, just hang the light and it is ready to go.
-Pan - 340 degrees non continuous.
-Tilt - horizontal (zero degrees) to minus 120 degrees.
-Focus - additional flexibility has been added to provide control of the beam spread. The center lamp panel is fixed; the mid and outer can be collectively rotated away from the center to provide an additional thirty degrees of coverage. (fifteen degrees per side)
-Pre-wired to mate with LRX powered I beam trolley.
-Positive bulb retaining rings including integrated grills for extra safety.
-Gel frame holders accepts two 48” X 66” frames.
-Easy external touch pad DMX addressing.
-Our exclusive easy to mount, mounting system. (patent pending).
-Convenient hand controller that can control up to thirty two fixtures.
-Power to operate robotics - 110/120 Volts AC - 50/60 Hertz - non dimmed line.
-Weight 170 pounds.

With features like: robotics built right into the fixture, external DMX addressing, par 64 type lamps and our
exclusive easy mount, mounting system and more, all add up to no wasted time. The fixture can be mounted on
most aerial lifts, using our approved condor mounting system or any place that truss can be installed, (cantilevered
from rooftops, hung in ceilings, etc.) Our positive fixture mounting means no chance of movement or weathervane
from the wind. Once the fixture is in place focusing can be done quickly & safely from the supplied hardwired DMX
hand controller or your DMX system, letting you put light exactly where you want, without the worry of operator
safety or exposure.